I've spent a lot of time these past couple weeks doing homework, so when I had a bit of down time over the weekend I decided to work on the car a bit. The passenger side door has slowly been progressing. Weekend before last I got the window cleaned up and ready to be put back in and got all the grime cleaned off the lifting components. This weekend I decided I would finish the insulation...
I had already coated the door in several layers of rust reformer and primer. The outer layer is actually rubberized undercoating. The idea being that will help deaden sound, keep dirt from sticking, and also seal it from rusting again. The next step was just to apply the Thermotec sound/heat shielding like I already had done of the driver's side (looks kinda cool actually). This time it went a lot smoother... No mis-cuts. Next thing to do is reinstall the window, then finish the power locks.
Getting a bit excited though... The engine should be done in the next two days! Will be ordering the transmission after I get back from my vacation. Plenty to do before then.
I had already coated the door in several layers of rust reformer and primer. The outer layer is actually rubberized undercoating. The idea being that will help deaden sound, keep dirt from sticking, and also seal it from rusting again. The next step was just to apply the Thermotec sound/heat shielding like I already had done of the driver's side (looks kinda cool actually). This time it went a lot smoother... No mis-cuts. Next thing to do is reinstall the window, then finish the power locks.
Getting a bit excited though... The engine should be done in the next two days! Will be ordering the transmission after I get back from my vacation. Plenty to do before then.
No comments:
Post a Comment